Skyjacker TT413ST Bedienungsanleitung
Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Skyjacker TT413ST herunter. Skyjacker TT413ST User Manual Benutzerhandbuch
- Seite / 4
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Pg 1I-TT430ST REV2 8-10
www.skyjacker.com
REQUIRED TOOL LIST:
Before beginning the installation, thoroughly & completely read these instructions & the enclosed
driver’s WARNING NOTICE. Affix the WARNING decal in the passenger compartment in clear view
of all occupants. Please refer to the Parts List to insure that all parts & hardware are received prior
to the disassembly of the vehicle. If any parts are found to be missing, contact SKYJACKER
®
Customer Service at 318-388-0816 to obtain the needed items. If you have any questions or
reservations about installing this lift kit, call SKYJACKER
®
Technical Assistance at 318-388-0816.
Make sure you park the vehicle on a level concrete or asphalt surface. Many times a vehicle is not
level (side-to-side) from the factory & is usually not noticed until a lift kit has been installed, which
makes the difference more visible. Using a measuring tape, measure the front & rear (both sides)
from the ground up to the center of the fender opening above the axle. Record this information
below for future reference.
Driver Side Front: Passenger Side Front:
Driver Side Rear: Passenger Side Rear:
:
• This lift is determined from the amount of lift to the front of the vehicle, while only lifting the rear
to a position level with the front.
• If larger tires (10% more than the stock diameter) are installed, speedometer recalibration will be
necessary. Contact your local Toyota dealer or an authorized dealer for details.
• After installation a qualified alignment facility is required to align the vehicle to factory
specifications.
Inhaltsverzeichnis
Seite 1 -
Pg 1I-TT430ST REV2 8-10www.skyjacker.comREQUIRED TOOL LIST:
Seite 2 -
1. With the vehicle on flat level ground, set the emergency brake & block the rear tires.2. Place a floor jack under the lo
Seite 3 -
There are six snap ring grooves located on the new Skyjacker strut body for 1" to 3" lift heights. The ring is installed
Seite 4
19. Using C-clamps, secure the leaf pack together & remove the center tie-bolt. (See Photo #10) Loosen the C-clamps
Verwandte Produkte und Handbücher für Für das Auto Skyjacker TT413ST
(4 Seiten)
(2 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.864 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern