Skyjacker 1035H Bedienungsanleitung PDF herunterladen

Camber / Caster Shim

Part # 1032H / 1035H

On Ford Twin Traction Beam models, the camber is adjusted by replacing the camber adjusting

bushing. Camber changes are determined by the angle at which the mounting bushing holds the ball

stud.

REMOVAL INSTRUCTIONS:

1. Remove the upper ball joint cotter pin & nut.

2. To help prevent a tight steering condition & aid in the seating of the bushing, remove the lower

ball joint cotter pin & loosen the nut to the end of the stud, but DO NOT remove.

3. Strike the inside of the spindle near the upper & lower ball joints to break the spindle loose from

the ball joint studs. Remove the old bushing using a pitman arm puller or similar tool.

INSTALLATION OF THE NEW BUSHING:

1. Partially tighten the lower ball joint stud nut to 40 Ft. Lbs. & lubricate the bushing. Install the

bushing over the ball joint stud. Place the old bushing on top of the new & tap down to seat in

place.

2. Using a 1 1/8” box wrench, rotate the bushing until the desired alignment is achieved. Position

into place using the closest notch possible.

3. Place the old bushing over the new bushing again & firmly tap the bushing down as far as

possible into the axle to correctly seat the taper of the bushing.

4. Install the upper ball joint stud nut & tighten to 95-110 Ft. Lbs. Advance (DO NOT LOOSEN) the

nut to the next castellation & install the new cotter pin.

5. Finish tightening the lower ball joint nut to 95-110 Ft. Lbs. Advance the nut to the next castellation

& install the new cotter pin.

6. Reinstall the tires / wheels & lower the vehicle & road test.

Note: Excessive spindle turning effort or poor steering returnability may be the result of not

following the proper tightening sequence or worn / bent ball joints.

I-1032H-1035H REV2 5-11

Part # 1032H

80-96 Ford F-150, Bronco, F-250 4WD

80-85 Ford F-350 4WD

Part # 1035H

83-89 Ford Ranger 4WD

83-90 Ford Bronco II 4WD

Install Here

Pg 1

www.skyjacker.com

1 2

Inhaltsverzeichnis

Seite 1 - Part # 1032H / 1035H

Camber / Caster ShimPart # 1032H / 1035HOn Ford Twin Traction Beam models, the camber is adjusted by replacing the camber adjusting bushing. Camber ch

Seite 2 - Jesús murió por ti

Check out our favorite ministries at:www.innministries.orgwww.familychurch.orgwww.kcm.orgJesus Forgives, Rocks Don’tJesus Christ Died For You.John

Verwandte Modelle: 1032H

Kommentare zu diesen Handbüchern

Keine Kommentare

Skyjacker 1035H Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Skyjacker 1035H herunter. Skyjacker 1035H User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: 1032H

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Skyjacker 1035H